3d wire bending machine is used for a period of time. In addition to correct operation methods, maintenance is also required to ensure its service life. The maintenance of 3d wire bending machine is a common topic, and the correct maintenance also needs to be learned. So today we will take a look at the special maintenance of the 3D wire bending machine.
1. Running in maintenance: the new machine or the overhauled machine must be run in maintenance during the running in period. When the machine is used within the specified running in period, the load and speed must be increased step by step according to the corresponding regulations, and the lubrication and tightening conditions must be comprehensively checked, and the overall condition of the machine must be observed If any abnormality is found, it must be solved in time. The key point of running in maintenance is to replace the lubricating oil of each part, lubricate each part, and tighten each bolt. Carry out secondary maintenance after the running in period.
2. Seasonal maintenance: the machinery shall be maintained once a year before summer or winter. The focus is on the fuel system, hydraulic system, cooling system and starting system. The following work shall be carried out according to the actual situation: replace the fuel and hydraulic oil, adjust the relative density of the battery electrolyte, take cooling or cooling measures, and clean the cooling system.
3. Shutdown for maintenance: When the mechanical equipment needs to be shutdown for a period of time due to seasonal factors (such as winter vacation), it shall be shutdown for maintenance. Mainly for cleaning, shaping, supporting, anti-corrosion and other work.
4. Storage and maintenance: storage and maintenance shall be carried out carefully according to storage requirements to reduce the erosion of long-term storage equipment by natural weather.
The above is about the special maintenance of the 3D wire bending machine, and I hope it will be helpful to you.